Difference between revisions of "Configure EA2478 Board"
From Klaus' wiki
(→Microwin) |
|||
Line 21: | Line 21: | ||
Change the IP address to suit your need and rebuild. | Change the IP address to suit your need and rebuild. | ||
+ | |||
+ | ==Configuring u-boot== | ||
+ | |||
+ | Originally the bootcmd is set to | ||
+ | |||
+ | <source lang="text"> | ||
+ | bootcmd=echo "Booting from NAND FLASH (may take a few secs)." ;run | ||
+ | </source> | ||
+ | |||
+ | In order to change this, or other environment variables containing long strings it is recommended to enclose the string in single-quotes (') | ||
+ | |||
+ | <source lang="text"> | ||
+ | setenv bootcmd 'echo "Booting from TFTP (may take a few secs)." ;run tftp_boot' | ||
+ | </source> |
Revision as of 09:38, 12 October 2013
These are a few of the configurations that is possible on the Embedded Artists EA 2478 board.
Microwin
ssh daemon
dropbear is a drop-in lightweight alternative to the full shh-daemon.
In make menuconfig Network Applications check the dropbear choice.
Set your network address at boot
In uClinux-dist/vendors/EmbeddedArtists/rc you can near the bottom set your preferred network address. Find a line looking like this:
ifconfig eth0 192.168.5.233 up
Change the IP address to suit your need and rebuild.
Configuring u-boot
Originally the bootcmd is set to
bootcmd=echo "Booting from NAND FLASH (may take a few secs)." ;run
In order to change this, or other environment variables containing long strings it is recommended to enclose the string in single-quotes (')
setenv bootcmd 'echo "Booting from TFTP (may take a few secs)." ;run tftp_boot'