Configure EA2478 Board

From Klaus' wiki
Revision as of 15:30, 11 October 2013 by Klaus (Talk | contribs)

Jump to: navigation, search

These are a few of the configurations that is possible on the Embedded Artists EA 2478 board.

Microwin

See MicroWin on EA board

ssh daemon

dropbear is a drop-in lightweight alternative to the full shh-daemon.

In make menuconfig Network Applications check the dropbear choice.


Set your network address at boot

In uClinux-dist/vendors/EmbeddedArtists/rc you can near the bottom set your preferred network address. Find a line looking like this: 

ifconfig eth0 192.168.5.233 up

Change the IP address to suit your need and rebuild.

Retrieved from ‘http://klaus.ede.ase.au.dk/index.php?title=Configure_EA2478_Board&oldid=863’