PB:Get an Internet connection
In order to let the PocketBeagle (PB) connect to the Internet a few preparations is needed.
Packets on the network is routed through a number of points. The first point a packet from the PB will run into is the Centos host. It has the IP address 192.168.6.1.
In order to let the Centos route traffic from the PB to the Internet Masquerading must be enabled in the firewall. Masquerading takes packets with the source address - in this case - 192.168.6.2 and changes the source address to be that of the Centos and finally routes the packet to the Internet interface - that will be your host operating system.
When packets arrives with responses from the Internet they will be sent to the Centos, which looks up in a table and from there knows that it has to change the destination address to that of the PB, i.e. 192.168.6.2. Complicated, yes, but it works if you are careful in setting up the necessary things.
Preparing the Centos development host
First open the firewall interface:
Next give your password.
Finally you have to click a number of times on the small arrow icon the the right (marked with red circle in the figure below). The click to set the check mark as shown in the blue circle below.
Close the firewall.
Preparing the PocketBeagle for connecting the Internet
Set up tiezone and time
To setup a correct timezone execute this on your Pocket:
]$ dpkg-reconfigure tzdata
select Europe and Copenhagen in the menu provided.
NOTE Below is a scratch pad, not valid information
From this point you can follow the instructions given on the BeagleBone Black part of the wiki and maybe also the instructions for the Windows setup, if you're using this as your host OS.
The next step could be to copy over your credentials from development host to the PB letting you login without password. Follow the instructions over at Linux Hints page.